Programing Top Models Ventus W/Futaba’s 10c Radio
Ch 1- Right Aileron
2- Elevator
3- Right Spoiler
4- Rudder
5- Left Flap
6- Right Flap
7- Left Aileron
8- Left Spoiler
For ailerons-
Plug your servos into channels 1 and 7 and activate aileron differential and adjust the rates to what you need.
Go to air-brake (crow) and make it active. You will have to adjust the rates to get what you need. Set it to the switch and position you want it active in.
Go to an open p-mix and make it active, master is CH6, slave is CH5, the rates are +100%, link is off and the switch does not matter and position is NULL.
Go to an open p-mix and make it active, master is OFS, slave is CH 6, the rate is +50%, link is on and the switch is Sw G and position is DOWN.
Go back to P-mix 1 and turn the link on.
Go to an open p-mix and make it active, master is OFS, slave is CH5, the rates are +37%, link is off and the switch and position is the same as your air-brake (crow).
Futaba R6014FS
For spoilers:
Go to the basic menu and go to AUX-CH and set ch 5, 6, 7, and 8 to NULL.
You may have to adjust the rates to get the amount of throw you want.
